Back to List

Bare Die Product Detail: 78L05 REV 2

Regulator output <= 300mA:
The 78L05 is a small-size optimized 5V fixed 3-terminal voltage regulator delivering 100mA of output current and equipped with internal limiting + thermal shutdown features for overload immunity. Optimized for industry smallest die size.

Optimized die size suits applications requiring 5V regulation within smallest footprint.

Features:
** END OF LIFE ** NOT RECOMMENDED FOR NEW DESIGN

Wide input voltage range
Internal Short-Circuit Current Limiting
Internal Thermal Overload Protection
No external components required
Provides Point-of-Source regulation with lower noise
x2 magnitude impedance improvement with lower bias current and noise when replacing Zener diode/resistor combinations
Can be used with power-pass elements to make high-current voltage regulators
Negative Voltage complement is 79L05

Vendor:
Silicon Supplies
Electrical Datasheet

Die Physical Data:
Footprint: 0.416mm² (644.802mil²)
Request Pad Layout

Product Families: Used for this device are tabulated below.

Regulator output <= 300mA

Functional:

Output: Fixed Output
Output Capacitor: Cap Free, Non-Ceramic

Specification:

V_{IN (MIN)}: 7.00V
V_{IN (MAX)}: 20.00V
I_{OUT (MAX)}: 0.10A
V_{OUT (MIN)}: 4.80V
V_{OUT (MAX)}: 5.20V
V_DO: 1,700mV
Accuracy: 4.0%
I_Q: 1.9000mA
Noise Figure: 42µVrms
PSRR @ 100KHz: n/a

Other Detail: Important information for this device is tabulated below.

Traffic light setting for Minimum Order Quantity indicates the following:

Green:Available from stock or at low factory MOQ.
Amber: Available on factory order with MOQ.
Red: High factory MOQ may apply, please ask for details.

Traffic light setting for High Reliability indicates the following:

Green: This bare die is specified and tested for use in high reliability applications.
Amber: This bare die can meet higher reliability specifications with additional testing & qualification, please ask for details.
Red: This bare die is not specified or specifically designed for use in high reliability applications.

Traffic light setting for Space Grade indicates the following:

Green: This bare die is qualified for space applications or has space level qualification data, please ask for details.
Amber: This bare die can be specified for space applications with additional testing and qualification, please ask for details.
Red: Suitability of this bare die for space applications is unknown and requires further qualification, please ask for details.